(601) 699-8246

|

hello@salvationrepair.com

CAMERA

  1. Home
  2. Posts

Canon Eos 5D Mark Ii Lcd Replacement Tutorial

Canon EOS 5D Mark II LCD Replacement Tutorial

Is your Canon EOS 5D Mark II’s LCD screen cracked or damaged? Don’t worry, we’ve got you covered In this tutorial, we’ll walk you through the steps to replace the LCD screen on your Canon EOS 5D Mark II. This repair is a bit tricky, but with the right tools and some patience, you can do it yourself. If you’re not comfortable with DIY repairs, you can always schedule a repair with us at Salvation Repair.

Canon EOS 5D Mark II LCD Replacement Tutorial

Step 1: Remove the Rubber Flap

Lift the rubber flap covering the input/output jacks. This will expose the screw that holds the LCD screen in place.

Remove the Rubber Flap

Step 2: Remove the Screw

Using a Phillips #000, remove the single 3.4 mm screw that holds the LCD screen in place. This screw is located under the rubber flap.

Remove the Screw

Step 3: Remove the Memory Battery

The memory battery can now be easily slid out of place. Be careful not to touch any of the internal components.

Remove the Memory Battery

Step 4: Peel Back the Rubber Cover

Peel back the rubber cover above the in/out ports to reveal two screw heads. Remove both 5.4 mm screws using a Phillips #0.

Peel Back the Rubber Cover

Step 5: Remove the In/Out Port Plastic Covering

Lift the in/out port plastic covering from the bottom where the backup battery used to be.

Remove the In/Out Port Plastic Covering

Step 6: Remove the Viewfinder Screws

Remove each 6.3 mm screw on either side of the viewfinder using a Phillips #0 screwdriver.

Remove the Viewfinder Screws

Step 7: Remove the Back Plate Screws

Remove the three 4.8 mm screws on the bottom of the back plate using a Phillips #0.

Remove the Back Plate Screws

Step 8: Peel Back the Rubber Covering

Peel back the rubber covering next to the menu dial to access the screw. Remove the single 3.4 mm screw using a Phillips #0.

Peel Back the Rubber Covering

Step 9: Remove the Back Panel

The back panel can now fall off easily by turning the device upside down. Be sure to catch it so the data ribbons do not tear or tug.

Remove the Back Panel

Step 10: Remove the Data Ribbon Cables

Remove each data ribbon cable from the motherboard by applying pressure down towards the motherboard and gently sliding your thumb upwards on the slot where the cable meets the motherboard.

Remove the Data Ribbon Cables

Step 11: Remove the LCD Screen

Remove each of the 3.4 mm screws holding in the LCD using a Phillips #0. Grip the wire attaching the speaker to the data ribbon cable and pull it out. The LCD is now free from the back panel.

Remove the LCD Screen

Congratulations You have successfully replaced the LCD screen on your Canon EOS 5D Mark II. If you’re not comfortable with DIY repairs or if you’re not sure about any of the steps, you can always schedule a repair with us at Salvation Repair. We offer a limited lifetime guarantee on all parts and labor.

0 Comment

Leave a Reply

Registration isn't required.