(601) 699-8246

|

hello@salvationrepair.com

13"

  1. Home
  2. Posts

Macbook Pro 13 Inch Unibody Mid 2009 Left Clutch Hinge Replacement

MacBook Pro 13 Inch Unibody Mid 2009 Left Clutch Hinge Replacement

Welcome to this repair tutorial for the MacBook Pro 13 Inch Unibody Mid 2009. In this article, we will guide you through the process of replacing the left clutch hinge. Please note that this tutorial is for the Mid 2009 model, and the steps may vary slightly for other models.

Before we begin, make sure you have the necessary tools and materials. You will need a Torx driver, a spudger, and a Phillips screwdriver. Additionally, it’s a good idea to have a can of compressed air and a soft cloth on hand to clean out any dust or debris that may be accumulated in the laptop.

Step 1: Remove the Lower Case

Start by removing the 10 screws that secure the lower case to the MacBook Pro. Seven of these screws are 3 mm Phillips screws, while the remaining three are 13.5 mm Phillips screws. Once the screws are removed, gently lift the lower case and push it toward the rear of the computer to free the mounting tabs.

lower case screws

Step 2: Disconnect the Battery Connector

For precautionary purposes, we advise that you disconnect the battery connector from the logic board to avoid any electrical discharge. Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

battery connector

Step 3: Disconnect the Camera Cable

Disconnect the camera cable by sliding it horizontally out of its socket. Pull the cable parallel to the surface of the logic board, in the direction of the optical drive. Do not pull straight up, or you will destroy the connector.

camera cable

Step 4: De-route the Camera Data Cable

De-route the camera data cable from the channel in the optical drive.

camera data cable

Step 5: Remove the Display Data Cable Bracket

Remove the two screws securing the display data cable bracket to the upper case. One of these screws is a 7 mm Phillips screw, while the other is a 5 mm Phillips screw.

display data cable bracket

Step 6: Remove the Left Clutch Hinge

Remove the single 5.2 mm T6 Torx screw securing the left clutch hinge nearest the display glass. Remove the remaining two 5.2 mm T6 Torx screws securing the left clutch hinge to the display. Finally, remove the left clutch hinge from the display.

left clutch hinge

That’s it! You have successfully replaced the left clutch hinge on your MacBook Pro 13 Inch Unibody Mid 2009. If you have any questions or need further assistance, please don’t hesitate to contact us at Salvation Repair.

Remember, at Salvation Repair, we offer a limited lifetime guarantee of all parts and labor. Customers can schedule a repair at https://salvationrepair.com/repair. We also offer free postage for mail-in repairs or on-site mobile repairs at your location for local customers in Mississippi.

0 Comment

Leave a Reply

Registration isn't required.