Replacing the Slider on a Coil Zipper

Step 1: Locate the Top of the Zipper

Start by locating the top of the zipper on the side with the slider. You can do this by gently pulling the zipper open and looking for the small metal or plastic stop that holds the slider in place.

Step 2: Peel Back the Fabric

Peel back any fabric that is covering the zipper stop. This will give you access to the stop and allow you to remove it.

Step 3: Cut the Stop

Use end nippers to cut the stop. Be careful not to damage the webbing behind the zipper.

Step 4: Remove Any Remaining Pieces

Carefully remove any remaining pieces of the stop using tweezers.

Step 5: Slide the New Slider Onto the Zipper

Slide the damaged zipper slider up and off of the zipper. Then, slide the replacement slider onto the zipper. You may need to tug a little to get it past where the old stop was.

Step 6: Add a New Zipper Stop

Grab a new zipper stop and insert the teeth into the webbing in the same place where the old stop was located.

Step 7: Bend the Metal Top

Use pliers to bend the metal top of the zipper stop around the edge of the webbing, poking the single tooth on the stop through the backside of the webbing.

Step 8: Crimp the Stop

Crimp the stop into place to secure it.

If you’re not comfortable with this repair, or if you’re not sure what you’re doing, consider scheduling a repair with Salvation Repair. Our experienced technicians can fix your zipper slider quickly and efficiently. And, as a bonus, we offer a limited lifetime guarantee on all parts and labor. Schedule a repair here.