Patagonia Fastener Repair Tutorial: Installing A Plastic Snap Using A Hand Press

Installing a Plastic Snap Using a Hand Press: A Step-by-Step Guide

Are you tired of dealing with broken plastic snaps on your favorite clothing or gear? Look no further In this tutorial, we’ll show you how to install a plastic snap using a hand press. With a few simple steps, you’ll be able to fix your stuff and get back to enjoying your favorite activities.

Step 1: Gather Your Materials

To start, you’ll need a few basic materials. These include a hand press, a plastic snap (cap and stud or socket), and the fabric you want to attach the snap to. Make sure to choose a snap that matches the size and type of your original snap.

Plastic snap components

Step 2: Measure and Mark the Fabric

Measure the diameter of the cap and socket to ensure they are the correct size for your fabric. Mark the spot where you want to attach the snap, making sure it’s centered and even.

Marking the fabric

Step 3: Insert the Cap and Stud or Socket

Insert the cap, rounded side down, into the cap fitting for the hand press. The shaft of the cap should face out. Then, insert the stud or socket into the corresponding fitting, making sure it snaps into place.

Inserting the cap and stud

Step 4: Assemble the Hand Press

Insert the cap fitting onto the fitting base of the hand press, and then insert the stud or socket fitting into the upper fitting holder. Tighten the screw on the side of the upper fitting holder to secure the fitting.

Assembling the hand press

Step 5: Align the Fabric and Press the Snap

Align the fabric in the hand press, making sure the mark you made earlier is centered over the shaft of the cap. Pull the handle of the hand press down in one continuous motion to set the snap.

Pressing the snap

Step 6: Inspect and Repeat if Necessary

Inspect both sides of the snap to ensure it’s laying flat and tight against the fabric. If the snap is not set all the way, reinsert it into the hand press and repeat the process.

Inspecting the snap

And that’s it With these simple steps, you should be able to install a plastic snap using a hand press. If you’re not comfortable with this process or if you’re unsure about any part of it, consider scheduling a repair with Salvation Repair. We offer a limited lifetime guarantee on all parts and labor, and our expert technicians will be happy to help you fix your stuff.

Leave a Reply

Your email address will not be published. Required fields are marked *