DIY Guide: Replace Nintendo DS Main Circuit Board in 10 Steps
Duration: 45 minutes
Steps: 10 Steps
Here’s how to swap out a Nintendo DS motherboard, or circuit board. The Nintendo DS is a cool dual-screen gaming device with wireless features and a built-in microphone. The main circuit board ensures all parts of the DS communicate seamlessly. So, if things start lagging or communication fails, it’s time for a motherboard makeover! You’ll need to remove the main motherboard to access the screens and other crucial parts. You can tackle this in 10 simple steps. If you need help, you can always schedule a repair.
Step 1
In the images, you’ll notice the repair pro is using a flathead screwdriver – and guess what? It works just like a Phillips #00 Screwdriver!
– Let’s kick things off by gently pulling the cartridge out of the console. Easy peasy!
– Grab your trusty Phillips #00 Screwdriver and go ahead and unscrew the little guy keeping the battery door snug on the back.
– Now, carefully take off the battery door and reveal the magic inside!
Tools Used
Step 2
– Grab a plastic opening tool or spudger to pop out the battery from the bottom. Don’t have one? No sweat, your fingernails can do the trick!
Tools Used
Step 4
If your DS has a lanyard hanging out, feel free to take it off! It’ll make unscrewing that top-left screw a breeze.
– Unscrew the seven 6.4mm Y00 screws from the back panel.
Step 5
– Gently work your fingers around the edges to pop off the back panel from the main case. It’s like peeling a banana, but way cooler!
– Carefully detach the back from the front and place it somewhere safe. You’re doing great!
Step 6
Watch out for that screwdriver! A little slip and you might end up giving the circuit board a new accessory it didn’t ask for!
– Let’s get started! Remove the four screws on the circuit board using a Phillips #00 screwdriver – easy peasy!
Tools Used
Step 7
Be gentle with those cables! Avoid using pliers to pull them, as they can get damaged pretty easily.
– Gently slide the black clip up to free those two hefty ribbon cables. You’ve got this!
– With a delicate touch, pull the ribbon cables down and out using your fingers. Easy peasy!
Step 8
Handle with care – those teeny-tiny ribbon cables can be super fragile, so let’s be gentle!
Tweezers can be super handy when tackling those tiny ribbon cables. A gentle pinch and you’re good to go!
– First things first, find those two tiny ribbon cables hiding just beneath the rightmost large ribbon cable. They’re waiting for your attention!
– Now, gently slide the locks for those small ribbon cables down to the side, and then you can carefully remove the cables. You’ve got this!
Tools Used
Step 10
– Guide those ribbon cables through the board’s opening like you’re threading a needle, nice and smooth.
– Gently lift and remove the circuit board, then set it aside. You’ve got this!
Success!
