DIY Guide: Step-by-Step Acer Iconia Tab A500 Screen Replacement
Duration: 45 minutes
Steps: 16 Steps
Ready to roll up your sleeves? This guide walks you through the steps to replace the screen on an Acer Iconia Tab A500. No need to stress—just follow along, and you’ll have your device looking sharp again in no time!
Step 3
– Pop out those 5mm screws holding the battery to the rest of the tablet.
– Grab your Phillips #00 Screwdriver and get those 5mm screws out.
Step 4
– Time to get started! Use the pointy end of your trusty spudger to carefully disconnect the battery from the motherboard. It’s like a little puzzle piece – just gently pry it off!
– The battery connector should slide right off, easy peasy! If you need help or get stuck, don’t worry – we’ve got you covered. Just remember to take your time and be patient.
Tools Used
Step 5
Heads up! Those four screws aren’t all identical, but don’t sweat it—this won’t mess with the speaker replacement.
– Spot the 4 screws and cable that keep the two speakers in place.
– Grab your trusty Phillips #1 screwdriver and unscrew those 2mm black screws.
– Pop out the 2mm silver screws.
Tools Used
Step 6
– Gently pop out the connector cable by nudging the edge of the black plastic insert. Easy does it!
Step 7
– The top speaker is tucked snugly under the motherboard—it’s playing hide and seek with you.
– To liberate this little guy, grab your trusty spudger and gently coax it out. Take it slow and steady!
Tools Used
Step 8
These screws come in a couple of sizes: the shiny silver ones are 5mm, while the sleek black ones are 2mm. Keep an eye out for them!
– Grab your trusty Phillips #1 screwdriver and let’s get those screws out from the edges of the tablet!
Tools Used
Step 9
– Gently lift those black flaps to set the flat cables free.
– Carefully detach this connector.
Step 10
– Grab your trusty spudger and gently disconnect the cables shown. It’s like unplugging tiny little bridges!
– Unearth the final motherboard screw hiding beneath the rightmost cable—a shiny, silver 5mm one. It’s the last guardian of the motherboard!
Tools Used
Step 11
– Gently pry up the two shiny gold connectors with your fingers—they’ll pop right off without a fuss!
– Next up, give that black flap a little lift to free the cable. It’s easier than it sounds!
Step 12
– Once you’ve successfully unplugged all those tricky cables, you can easily lift the motherboard right out. You’re doing great!
Step 13
– Carefully take off the components located near the edge of the tablet by unscrewing the 5mm screw that’s keeping the top in place. You’ve got this!
Step 14
– Gently lift up that silver casing to reveal the back of the screen—you’re one step closer to tech glory!
Step 16
– To put your device back together, just follow these steps in reverse. If you need help, you can always schedule a repair.
– Cancel: Nope, didn’t complete it.
– Way to go!
Success!
