How To Replace VTech Kidizoom Smartwatch DX2 Battery – DIY Guide
Duration: 45 minutes
Steps: 9 Steps
Is your smartwatch refusing to juice up despite testing the cables? It might be time to swap out the battery. This guide will walk you through the process step by step, so let’s get that watch ticking again!
Step 1
– Flip that watch over so its back is chillin’ up top, ready for action.
Step 2
– Alright, grab your trusty Phillips #00 screwdriver and carefully unscrew the four 6.0 mm screws hanging out in each corner of the watch. Once those little guys are out, you can pop off the backplate and keep the repair rolling!
Tools Used
Step 3
– Carefully pop off the backplate with a smooth, steady motion.
Step 4
– Pop that backplate off, then carefully lift the master switch off the circuit board like you’re picking up a delicate treasure.
Step 5
– Grab your Phillips #00 screwdriver, and let’s unscrew that teeny tiny 0.6 mm screw!
Tools Used
Step 6
– Gently pop the speaker out of its cozy case, but be sure to keep it connected to the motherboard for now!
Step 7
– Grab those tweezers and gently pop up the little bar holding the screen connection. Easy does it!
– Time to free the motherboard! Carefully lift it out of the device like the pro you are.
Tools Used
Step 8
– Gently coax the battery away from the circuit board using your trusty plastic opening tool – it’s time to set that battery free!
Step 9
– Ready to put it all back together? Just follow these steps in reverse, and your gadget will be good to go!
– Cancel: Didn’t quite finish? No worries, there’s always next time.
– If you’re stuck or something feels off, you can always schedule a repair for a helping hand.
Success!
