How to Open Samsung Galaxy Watch4 Classic – Step-by-Step Guide
Duration: 45 minutes
Steps: 5 Steps
Ready to pop open the back of your Samsung Galaxy Watch4 Classic? Let’s carefully remove the back cover with some steady hands and a touch of patience!
Step 1
– Alright, before diving into this repair adventure, make sure to unplug your watch from the charger and give it a little power nap by turning it off.
– Time to say goodbye to the watch band! Go ahead and remove it.
Step 2
– Let’s get started! Use a trusty Tri-point Y00 screwdriver to remove the four 4.0 mm-long screws that keep the back cover in place. Take your time and make sure they’re all out before moving on to the next step.
Tools Used
Step 3
Don’t get too eager to remove that back cover just yet! The sensor flex cable is still hooked up to the motherboard, so hang tight for now.
– Slide an opening tool into the groove where the back cover meets the metal frame.
– Give the tool a little twist to pop open a gap.
Step 4
– Flip the watch so it’s chilling face down.
– Gently swing open the back cover like you’re opening a little treasure chest—fold it over the gap you just made.
– Grab the flat end of your trusty spudger and carefully pop up the sensor flex cable to disconnect it from the motherboard. Easy peasy!
Tools Used
Step 5
– Ready to put your device back together? Just reverse these steps, and you’ll be good to go!
– Got stuck or things didn’t pan out as planned? No worries—try some quick troubleshooting, or reach out to our Answers community for a helping hand.
– Cancel: I didn’t finish this guide.
– If you need help, you can always schedule a repair.
Success!
