Xbox One Elite Controller Daughterboard Replacement Guide
Duration: 45 minutes
Steps: 9 Steps
Step 1
No need to worry about the rubber! It’s already seen better days on this controller.
– Use a pry tool to carefully pop off the side panels. You’ve got this!
Step 2
– Unscrew the five Torx Security Bit (TR9) screws and let’s get this show on the road!
Step 3
Watch out for that ribbon in the next step – it’s super important to keep it intact!
– Gently pry open the panel next to the 3.5mm port, and let the adventure begin!
Step 4
Hey there! This ribbon cable is super delicate. It’s like a tiny little lifeline for your device. Go easy on it, okay? Just be gentle. Don’t pull too hard, and you’ll be golden.
– Give that connector a gentle nudge to pop it up and say goodbye to the ribbon cable with ease!
– Ribbon Cable
Step 5
– Let’s get started by removing the 2 Torx (T6) screws – this is the first step to unlocking your device’s inner workings!
Step 6
– Carefully detach the 4 wires on each side; these little guys are in charge of the vibrations and the RT LT functionality. You’re doing great!
Step 7
– Gently lift from the top edge of the controller on the sister board. Just take it slow and steady, and you’ll be golden!
Step 8
Keep an eye on that sync button! It’s easy to misplace, so give it a little extra love as you go.
Removing this part will also take out the left and right brackets, which are conveniently attached as a single unit, making the process a bit easier for you
– Gently pry the middle section upwards, starting from the side with the home button.
Step 9
– To put everything back together, just follow these steps in reverse – easy peasy!
– If you didn’t quite get it done, no worries! You can always schedule a repair and let the pros handle it.
– You’re all done! Pat yourself on the back, you’ve successfully completed this repair guide from Salvation Repair.
Success!
