DIY Guide to Replace Tool Mounts on Power Tool Soldering Iron
Duration: 45 minutes
Steps: 2 Steps
Hey there, repair champ! Just a little heads up: be super careful when handling those delicate parts. If things get tricky, no worries at all! Just schedule a repair and let the pros take over!
Ready to swap out those Tool Mounts on your FixHub Portable Power Station? You’ve come to the right place! If you’re feeling creative and want to whip up your own mounts or accessories, check out the 3D model here. And remember, if you need help, you can always schedule a repair.
Step 1
– Grab your trusty Phillips screwdriver and let’s tackle those two 6 mm-long screws holding the tool mounts on each side of the power station. You’ve got this!
Step 2
– Grab those tool mounts and give them a gentle tug to pop them off both sides of the power station. You’ve got this!
– Remember, the tool mounts have a special way to fit back in. When you’re putting it all together again, just line up those pins on the mounts with the holes in the enclosure. Easy peasy!
