DIY: How to Open Samsung Galaxy Watch5 – Step-by-Step
Duration: 45 minutes
Steps: 5 Steps
Ready to dive in? Let’s pop off the back cover of your Samsung Galaxy Watch5 and get things rolling!
Step 1
– First things first, let’s give your watch a little break from its charger and power it down. It’s time to let it rest!
– Next up, gently remove the watch band. You’re doing great!
Step 2
– Grab your Tri-point Y00 screwdriver and tackle those four 4.1 mm screws holding the back cover in place.
Tools Used
Step 3
Hold your horses! Don’t go yanking off that back cover just yet. The sensor flex cable is still cozy with the motherboard.
– Slide an opening tool into the little gap between the back cover and the shiny metal frame.
– Give that tool a twist to loosen the gasket and open up a nice little space.
Step 4
– Gently place the watch face down on a soft surface.
– Carefully open the back cover at the little gap you’ve just made.
– Grab a spudger and gently pry the sensor flex cable away from the motherboard by lifting the press connector straight up from its socket.
– Now’s a great time to power on your device and check your handiwork before sealing it back up!
Tools Used
Step 5
– Ready to put your device back together? Just reverse these steps and you’re good to go.
– Ran into a hiccup? No worries! Try some basic troubleshooting, or reach out to our Answers community for a helping hand.
– Not feeling it? Hit ‘Cancel: I did not complete this guide.’ No judgment here.
– If you need help, you can always schedule a repair.
Success!