DIY Samsung Galaxy Mega Front Display Replacement Guide

Duration: 45 minutes
Steps: 6 Steps

Alright, let’s get this show on the road! We’re about to give your Galaxy Mega a makeover with a brand new front LCD assembly. This is a step-by-step guide to help you get the job done right. Don’t worry if you’re a little unsure, we’ll be right here to help you along the way. And if you need any extra assistance, you can always schedule a repair.

Step 1

– Alright, let’s tackle that shattered screen! First, cover it up with some tape to protect yourself and keep everything in place. Think of it like a little first-aid for your phone.

– Flip the phone over and give that battery door a little nudge. Once it’s off, the battery should be ready to come out too.

Step 2

– Grab your trusty Phillips and take out all 14 visible screws. We’re going in!

– Gently pop off the speaker component with your pry tool. Go slow and steady to keep it intact. If you need help, you can always schedule a repair

Step 3

– Grab your trusty pry tool and make your way around the edges of the phone, gently separating the rear assembly frame from the main device.

– The frame might try to trick you into thinking it’s stuck up top, but trust us! Focus your attention in the middle to find the magic spot for separation.

– Once you’re all set, go ahead and fully detach that rear assembly frame from the device like a pro!

Step 4

– Alright, let’s get this LCD flex cable outta there! Use a spudger or pry tool to gently lift it off the logic board.

– Next up, grab your trusty Phillips screwdriver and remove that lone screw holding the camera protection plate in place.

– Time to say hello (and goodbye) to the front camera! Go ahead and remove it.

Tools Used
  1. SpudgerSamsung Galaxy Mega  (SGH-M819N) Front Display Assembly Replacement

Step 5

– Get ready to unlock your device’s screen by gently heating it up with a heat gun while using a pry tool to carefully work your way around the edges.

– Use at least 3 guitar picks to keep the screen separated from the device as you make your way around – it should start to lift off nicely. Remember to take your time and be patient.

– Save the bottom area for last and be careful not to damage the back cable with your tools. If you need help, you can always schedule a repair

Step 6

– Clean your device first and then follow the steps in reverse. If you need help, you can always schedule a repair

Leave a Reply

Your email address will not be published. Required fields are marked *

🍪
Have a cookie! This site uses cookies to enhance your experience. Opt-Out Options.