How to Replace Samsung Galaxy Note Front Facing Camera – DIY Guide
Duration: 45 minutes
Steps: 17 Steps
Let’s get this done! This guide will walk you through replacing the front-facing camera in your Samsung Galaxy Note. Feeling a little intimidated? Don’t worry, we’ll make it a breeze! If you need help, you can always schedule a repair.
Step 1
– Grab the stylus cap and gently pull it out from its cozy spot in the midframe.
Step 2
– Let’s get this party started! Grab your trusty plastic opening tool (or maybe your fingernail, if you’re feeling adventurous) and gently pry in the little divot near the rear-facing camera, right by the volume buttons. You got this!
Step 3
– Let’s get started by carefully lifting and removing the rear case from your phone. Take your time and make sure it’s completely off before moving on to the next step.
Step 5
– Gently nudge the microSD card into its slot using the flat end of a spudger or your fingernail until you hear that satisfying click – it’s like music to your ears.
– Once you’ve heard the click, let go of the card and it should pop right out of its slot, easy peasy.
– When you’re ready to put everything back together, simply push the microSD card into the slot until it clicks into place. If you need help or get stuck, you can always schedule a repair with Salvation Repair.
Tools Used
Step 6
– Hey there! Toss that microSD card outta its comfy little slot in the midframe. If you’re feeling stuck, you know what to do – schedule a repair! No worries, we’ve got your back!
Step 7
– Grab a plastic opening tool or just your trusty fingernail, and gently nudge that SIM card out of its cozy little home.
Step 8
– Gently push the SIM card out of its slot with your thumb, and then completely remove it from your device. If you need help, you can always schedule a repair
Step 9
– Let’s get started by removing the nine 3.4 mm Phillips #00 screws that hold the midframe in place on the display assembly. If you need help, you can always schedule a repair
Step 10
– Alrighty, tech aficionado! Let’s flex our repair skills and slide that trusty plastic opening tool into the space left of the power button between the midframe and front panel gang. Give ’em a gentle nudge to separate ’em, and voila – you’re on your way!
Step 11
– Now it’s time to get this repair started – slide that plastic opening tool down the seam and let’s get this fixed!
Step 12
– Let’s get this party started! Gently slide your trusty plastic opening tool between the midframe and the display assembly, right next to the headphone jack.
– Now, glide that tool along the top edge of your phone, like you’re showing off your sweet dance moves.
– Keep on movin’ and groovin’ that tool around the whole perimeter of your phone until the midframe and display start to say goodbye. If you need help, you can always schedule a repair.
Step 14
– Now it’s time to disconnect the headphone jack/earpiece speaker assembly cable connector – simply use the flat end of a spudger to get the job done. If you need help, you can always schedule a repair
Tools Used
Step 15
– Unscrew those two 3 mm Phillips #00 screws that are holding down the upper display assembly bracket. You’re almost there!
Step 16
– Grab your tweezers, or simply use your fingers, and pop off the upper display assembly bracket. If you need help, you can always schedule a repair
Tools Used