How to Replace Samsung Galaxy Note Speaker Enclosure – DIY Guide

Duration: 45 minutes
Steps: 15 Steps

Ready to get your groove back? This guide will help you swap out the speaker on your Samsung Galaxy Note. Let’s get started!

Step 1

– Grab hold of the stylus cap and give it a gentle tug to pop it right out of its spot in the midframe.

Step 2

– Use a plastic opening tool or your fingernail to gently pry in the notch to the right of the rear-facing camera, near the volume buttons. If you need help, you can always schedule a repair.

Step 3

– Let’s get started by carefully lifting and removing the rear case from your phone. This is the first step in giving your device a brand new lease on life. If you need help, you can always schedule a repair

Step 4

– First, slide your finger into the notch of the battery compartment – it’s time to set that battery free.

– Now, gently press the battery towards the rear-facing camera while pulling it outward. You got this.

Step 5

– Use the flat end of a spudger, or your fingernail, to give that microSD card a little nudge deeper into its slot until you hear a satisfying click.

– After that click, let go of the card and it’ll pop right out! You’re a pro!

– For reassembly, just push the microSD card back into the slot until you hear that sweet click. You’re on your way! If you need help, you can always schedule a repair

Tools Used
  1. SpudgerSamsung Galaxy Note Speaker Enclosure Replacement

Step 6

– Alright, time to give that microSD card a little vacation! Gently slide it out of its cozy slot in the midframe. It’s like sending it off on a mini-adventure. Don’t worry, it’ll be back soon.

Step 7

– Grab a plastic opening tool or your trusty fingernail and gently nudge that SIM card out of its cozy little home.

Step 8

– Gently push the SIM card out of its slot with your thumb, and then completely remove it from your device. If you need help, you can always schedule a repair

Step 9

– Carefully take out the nine 3.4 mm Phillips #00 screws that are holding the midframe snugly against the display assembly. You’re doing great!

Step 10

– Let’s get this party started! Slide your plastic opening tool in between the midframe and front panel assembly, right next to the power button. Give it a gentle pry and we’ll be on our way!

Step 11

– Let’s get this party started! Slide the plastic opening tool down the seam. It’s like a dance, except way cooler.

Step 12

– Alright, let’s get this party started! Grab your trusty plastic opening tool and slide it in between the midframe and the display assembly, just to the left of the headphone jack.

– Now, gently slide that tool along the top edge of your phone, like you’re giving it a little high five.

– Keep on going around the perimeter of the phone, and pretty soon, you’ll have that midframe popping right off. It’s like a little phone dance party!

Step 13

– Let’s separate the midframe from the display assembly. It’s like a mini-break for your device!

Step 14

– Let’s get started by removing the three 3 mm Phillips #00 screws that hold the speaker enclosure in place on the front panel assembly. If you need help, you can always schedule a repair

Step 15

– Let’s get started by carefully removing the speaker enclosure from the display assembly. If you need help, you can always schedule a repair

Leave a Reply

Your email address will not be published. Required fields are marked *

🍪
Have a cookie! This site uses cookies to enhance your experience. Opt-Out Options.