Replace Lenovo Vibe Z2 Pro Charging Assembly: Step-by-Step Guide
Duration: 45 minutes
Steps: 19 Steps
So, you swapped out that tired battery, but your phone’s still playing hard to get when it comes to charging? Don’t worry, you’re not alone! It might be time to give that charging assembly a little love. This step-by-step guide will show you how to replace it and get your phone juiced up in no time.
Step 1
– Unscrew the 4.9 mm torx head screws that are chillin’ on the camera plate at the back of your phone.
Step 2
– Unscrew those pesky 3.65 mm Torx head screws hanging out at the bottom of your phone and let’s get this party started!
Step 3
– Gently pop out the SIM card tray by using a pin to press into the tiny hole on the side of your phone. It’s a little nudge and voila!
Step 4
– Gently glide the Spudger into the little opening between the phone and its backplate to help them part ways.
Tools Used
Step 5
– Gently wiggle and lift the backplate off the phone—no rush, it’s not going anywhere!
Step 6
– Gently peel back that protective film using your fingers. You’ve got this!
Step 7
Whenever you’re diving into a repair adventure, grab that trusty black nylon spudger! It’s your best buddy, especially when you’re working near those tricky batteries.
– Gently lift up any adhesive strips that are keeping the battery snug in its home, using your trusty fingernail or a spudger. You’re doing great!
Tools Used
Step 8
– Carefully lift the orange battery ribbon cable using a spudger to disconnect it. You’ve got this!
Tools Used
Step 10
– Carefully take out the 3.15mm Phillips Head #000 screws from the motherboard. You’ve got this!
Step 11
– Gently lift the black hinges to free those two ribbon cables, and give them a little tug with your tweezers to disconnect. You’re doing great!
Tools Used
Step 12
– Time to give that camera connector a gentle nudge! Just disconnect it, and you’ll be on your way to victory!
Step 14
– Gently pop off the plastic brace resting along the top edge of your phone. You’ve got this!
Step 15
– Time to give that antenna a little break! Carefully detach it from the bottom screen plate. It’s like giving it a little vacation.
Step 16
– Time to give that motherboard a little lift! Gently, gently, now…
– Now it’s time to say ‘see ya later’ to the camera. Just pull it out from behind the motherboard – no drama, just a smooth exit.
Step 17
– Let’s get that motherboard out of there! Use a spudger to gently disconnect the charging port assembly cable and the screen connection cable. Now, carefully lift that motherboard right out!
– You’re doing great! The motherboard is now free and ready for the next step. If you need help, you can always schedule a repair
Tools Used
Step 18
– Alright, let’s loosen up those screws holding the charging assembly in place! Grab your trusty Phillips head screwdriver (size 3.6 mm) and give those screws a gentle twist to remove them.
Success!
