Samsung Galaxy S24 Plus Rear Cameras Replacement Guide

Duration: 45 minutes
Steps: 36 Steps

Hey there! This guide’s gonna help you swap out those rear cameras on your Samsung Galaxy S24+ like a pro. Don’t worry, it’s easier than you think. We’ll walk you through it step by step. If you need help, you can always schedule a repair.

Step 1

– First things first, let’s disconnect any cables hanging out of your phone. Give it some space!

– Next up, press and hold the side key along with the volume down button, then tap ‘Power off’ to send your phone into a well-deserved nap.

Step 2

– Heat up an iOpener and place it on the right edge of the back cover for two minutes.

Step 3

– Alright, time to get this party started! Grab your trusty suction handle and stick it to the back cover, aiming for the center of the right edge. Make sure it’s nice and secure.

– Now, give that suction handle a good pull! You want to create a little gap between the cover and the frame. Think of it like opening a door with a little help from your friend (the suction handle).

– Time to sneak in! Carefully insert an opening pick into the gap you just made. This is where the real fun begins.

Tools Used
  1. iOpenerSamsung Galaxy S24 Plus Rear Cameras Replacement
  2. Suction HandleSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 4

– Let’s get this party started! Slide that pick along the right edge, like you’re giving the phone a little shimmy, to loosen up that adhesive.

– Now keep that pick chilling near the bottom right corner, so the adhesive doesn’t get cozy again. You’ve got this!

Step 5

– Let’s get this party started! Warm up the back cover with a heated iOpener for about two minutes. This will make it easier to loosen things up.

Tools Used
  1. iOpenerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 6

– Now, let’s get that bottom right corner separated! Give the opening pick a little spin to loosen up the adhesive. You got this!

Step 7

– Now it’s time to bring in some backup – insert a second pick at the bottom right corner to help loosen things up.

– Gently slide the opening pick over to the bottom left corner to break the adhesive’s hold.

– Leave that pick right where it is, in the bottom left corner, to keep the adhesive from sneaking back into place. If you need help, you can always schedule a repair

Step 8

– Warm up that trusty iOpener and gently press it against the left edge of the back cover for about two minutes. You’re doing great!

Tools Used
  1. iOpenerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 9

– Twist the opening pick around the bottom left corner to peel back that adhesive like a pro!

Step 10

– Let’s get this party started! Insert a third opening pick at the bottom left corner.

– Now, slide the pick towards the top left corner, gently separating the adhesive.

– Leave the pick near the top left corner to keep that pesky adhesive from sealing itself back up. Don’t worry, we’ve got this!

Step 11

– Time to get this repair started. Apply a heated iOpener to the top edge of the back cover for about two minutes. If you need help, you can always schedule a repair

Tools Used
  1. iOpenerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 12

– Now it’s time to get this repair started – gently rotate the opening pick around the top left corner to loosen the adhesive and get things moving.

Step 13

– Let’s loosen things up! Take your fourth opening pick and slide it into that top left corner.

– Slide the pick toward the top right corner, gently separating the adhesive. It’s like giving the phone a little hug, but with a tool!

– Keep that pick in place near the top right corner. You don’t want that adhesive getting cozy again, do you?

Step 14

– Align the tip of your trusty opening pick with the flash.

– Gently slide the pick beneath the top edge of the back cover until you feel it catch on the adhesive.

– Continue to glide the pick down towards the bottom of the phone while carefully lifting the cover until it pops free from the sticky stuff.

Step 15

– Start by popping off that back cover like a champ!

– Now, as you get ready to put everything back together:

– Break out those tweezers or just use your fingers to tackle any leftover adhesive on the back cover and the phone itself. If you’re having a tough time, a little heat or some isopropyl alcohol (at least 90%) along with a coffee filter or lint-free cloth can make it a breeze!

– And hey, if you’ve got custom-cut adhesives, don’t forget to check out the guide!

Step 16

– Time to get those nimble fingers working! Use a spudger to gently pry up and disconnect the wireless charging coil press connector from the motherboard.

– Now, let’s reconnect those connectors with a little finesse! Line up the connector carefully over its socket, and give it a little press with your fingertip—one side at a time—until it clicks into place. Don’t force it; just be patient. If things get tricky, reposition it and try again. You got this!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 17

– Grab your trusty Phillips screwdriver and remove the thirteen 3.5mm-long screws that hold the wireless charging coil and loudspeaker in place:

– You’ll find six screws securing the wireless charging coil – take those out first

– Next, remove the seven screws that keep the loudspeaker locked down. If you need help, you can always schedule a repair

Step 18

– Time to get started. Insert the point of a spudger into the notch at the top left corner of the loudspeaker – it’s marked with an arrow to help you out.

– Gently pry up to unclip the loudspeaker from the frame. If you need help, you can always schedule a repair

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 19

– Give that loudspeaker a gentle lift with your fingers, separating it from the frame.

– Now, let’s detach the wireless charging coil and loudspeaker from the frame – they’re ready for a new adventure!

– Time to reassemble! Give the loudspeaker’s edges a little squeeze to clip it back into the frame before screwing it back in place. You’ve got this!

Step 20

– Let’s get that battery connector unplugged! Use a spudger to gently pry it up and disconnect it. If you need help, you can always schedule a repair.

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 21

– Time to get those connectors unhooked! Use a spudger to carefully pry up and disconnect both interconnect cable press connectors from the daughterboard. Don’t worry, it’s just like unplugging a phone charger. If you need help, you can always schedule a repair.

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 22

– Time to get connected – or rather, disconnected. Use a spudger to carefully pry up and release both interconnect cable press connectors from the motherboard. If you need help, you can always schedule a repair

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 23

– Let’s get started by carefully removing the interconnect cables from your phone. Take your time and gently pull them out.

Step 24

– Grab your trusty spudger and gently wiggle it to lift up and disconnect that earpiece speaker press connector. You’ve got this!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 25

– Let’s get this earpiece speaker out! Grab your trusty Phillips screwdriver and give those five 3.5 mm screws a spin to loosen them up. You got this!

Step 26

– Gently slide the flat end of your spudger between the bottom edge of the earpiece speaker and the metal plate on the motherboard. You’re doing great!

– Twist that spudger like you mean it to unclip the earpiece speaker from the frame and pop it out. You’re making progress!

– When it’s time to put everything back together, start by inserting the top edge of the earpiece speaker into the frame before pressing down to clip it back in. You’ve got this!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 27

– Let’s get that upper antenna connector unplugged! Slide the tip of your trusty spudger under the top left corner of that connector.

– Now, gently pry it up and give it a little wiggle to disconnect the upper antenna connector from the motherboard. You’ve got this!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 28

– Time to get started – carefully insert the tip of a spudger under the bottom right corner of the front camera press connector, making sure not to damage any surrounding components.

– Gently pry up and disconnect the front camera press connector from the motherboard. If you’re not feeling confident, don’t worry – you can always schedule a repair with Salvation Repair for some expert help.

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 29

– Grab your trusty spudger and gently pry up those display and lower antenna cable connectors from the motherboard. It’s easier than it sounds, and you’ve got this!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 30

– Grab your trusty Phillips screwdriver and let’s tackle those two 3.5 mm-long screws holding the motherboard in place. You’ve got this!

Step 31

– Slide the flat end of a spudger between the top edge of the motherboard and the phone frame, right near the earpiece speaker cutout.

– Gently pry against the frame to lift the motherboard out of its slot. Go ahead and remove it!

– When you put things back together, make sure all the cables are out of the way before you drop that motherboard back into the frame.

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 32

– Flip that motherboard over, let’s give that rear camera connector a peek!

– Grab your trusty spudger and gently pry up that ultrawide camera connector. We’re going to give it a little break, just like you deserve after this repair!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 33

– Gently slide those pegs on the ultrawide camera out of their cozy spots on the motherboard to set it free.

Step 34

– Let’s free that camera! Use a spudger to gently pry up and disconnect the main camera press connector.

– Now that it’s unplugged, carefully lift the main camera off the motherboard. You got this!

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 35

– Let’s get started by using a spudger to carefully pry up and disconnect the telephoto camera press connector.

– Next, gently lift the telephoto camera off the motherboard and remove it – you’re making great progress!

– When it’s time to put everything back together, make sure to install the rear cameras in the correct order so they fit together seamlessly:

– Start with the Telephoto camera (it’s the small one with a metal back)

– Then add the Main camera (the large one with a metal back)

– Finally, install the Ultrawide camera (it’s the one with a plastic back) – you’re almost done!

– If you need help or get stuck along the way, don’t worry – you can always schedule a repair with Salvation Repair for some expert assistance.

Tools Used
  1. SpudgerSamsung Galaxy S24 Plus Rear Cameras Replacement

Step 36

– Congratulations, you’re all set to swap out those rear cameras!

Leave a Reply

Your email address will not be published. Required fields are marked *

🍪
Have a cookie! This site uses cookies to enhance your experience. Opt-Out Options.