Step-by-Step Guide: Nike SportWatch GPS Front Panel Replacement

Duration: 45 minutes
Steps: 6 Steps

In this guide, we’ll be replacing the front panel of your watch! Get ready to dive in as we take it apart completely and use a handy heating device to make removing the screen a breeze. Let’s get started and give your watch a fresh new look!

Step 1

– Flip the watch over so the back is facing up. Grab your trusty size #000 Phillips head screwdriver and unscrew those six 5 mm long screws on the back. You’ve got this!

Step 2

– Gently pull the band away from the main board to carefully separate the watch. Take your time here, no rush!

Step 3

– Up at the top of the main board, you’ll spot a couple of tiny #000 screws, each 2.5 mm long. Grab your trusty size 000 Phillips head screwdriver and get those little guys unscrewed. Nice and easy!

Step 4

– Grab the blue plastic opening tool and gently pop the main board out from the front panel.

Step 5

– Grab your trusty iOpener and give it a quick spin in the microwave for about a minute, or until it’s nice and toasty. Once it’s warmed up, place it on the front screen of your watch. Now just let it chill there for a minute!

Tools Used
  1. iOpenerNike SportWatch GPS Front Panel Replacement

Step 6

– Ready to wrap it up? Just work your way back through these steps in reverse, and your device will be good as new!

– Not feeling it? No worries, you can always schedule a repair.

Success!

Leave a Reply

Your email address will not be published. Required fields are marked *

🍪
Have a cookie! This site uses cookies to enhance your experience. Opt-Out Options.