Xbox 360 E RF Module Replacement Guide: Step-by-Step Tutorial

– Insert the Spudger into the gap between the Xbox’s grated top panel and the bottom body, where the rubber feet are located. Make sure it’s snug in there.

– Now, gently pry the top panel away from the bottom body by pulling the Spudger back like a lever. Keep it firmly in place in the gap as you do this.

– Gently slide the spudger along the gap you’ve created between the grated panel and the bottom body of the Xbox – you’re making great progress!

– As you go, periodically pull back on the spudger like a lever, keeping it firmly in place in the crevice. You’re doing a fantastic job of loosening things up!

– Keep sliding that spudger around the left side of the Xbox – you’re doing great!

– Now lift that top panel right off – you’re almost there!

– Gently slide the spudger into the gap between the right grated surface and the upper part of your Xbox. Starting away from the vent makes it a breeze!

– Lift the spudger up like a pro, using it as a lever while keeping it snugly pressed into that crevice.

– Gently glide that spudger along the gap to pop apart the grated face from the top body. You’ve got this!

– Give that spudger a little shimmy in the gap as you slide it to help loosen the bottom plate.

– Run the spudger along the edge, making sure to cover the entire perimeter of the bottom panel.

– Gently lift off the bottom panel.

– Look for the Xbox logo next to your CD drive. Right next to it? Yeah, that’s the spot. Go ahead and give that area a little press, and watch the disk tray panel pop right off! Easy peasy, right?

– Start on the left side, where there’s no grate, and glide that trusty spudger along the edge until you hit the grated section. Remember to support the part you’re separating as you move along. You’ve got this!

– Keep that panel nice and wide open! It’s a breeze if you use a spudger to gently keep it apart, but hey, your hands work too if you prefer a more hands-on approach.

– Swing the Xbox to the left and say hello to the clip that’s holding the front panel snug against the body. Slide your spudger into the little gap to pop that clip free. You might need to do a little wiggle dance with the spudger. Once it’s loose, the front panel will be much easier to handle!

– Turn the Xbox around so the backside is facing you. Keep the gap nice and open, we’re getting to the good stuff!

– Find that sneaky clip and gently slot the spudger in to pop it out.

– Keep gliding that spudger along the crease to free any clips still hanging on. You’ve got this!

– Once all the clips are freed and the front panel is ready to go, simply pull it off. Easy peasy!

– Locate the charming brown section where the ribbon cable makes its grand entrance into the green board. Gently lift the brown piece up and give a little tug on the plastic tab at the end of the ribbon to set it free!

– First up, take a look at the device’s body and find that snazzy green panel hanging out to the right of the CD drive.

– Next, grab your trusty T8 Torx screwdriver and unscrew those two 6 mm screws up at the top left and middle right. You’ve got this!

– Now, give the middle of that green board a gentle tug to pull it out. Easy peasy!