Xbox One Elite Controller Motherboard Replacement: DIY Guide
Duration: 45 minutes
Steps: 7 Steps
Step 1
No need to worry about the rubber – it’s already seen better days on this controller, so you can leave it be.
– Let’s get those side panels off! Use a pry tool to carefully pop them loose. You got this!
Step 2
– Unscrew the 5 Torx Security Bit (TR9) screws like a pro!
Step 3
Watch out for that ribbon in the next step! Let’s keep it intact as we go along.
– Let’s get started by carefully prying the panel next to the 3.5mm port. Take your time and make sure you’re gentle, we don’t want any accidental damage.
Step 4
Handle the ribbon cable with care—let’s keep it in one piece!
– Give that connector a little lift and the ribbon cable will pop right out! No need to wrestle with it.
– Ribbon Cable
Step 5
– Unscrew those 2 pesky Torx (T6) screws and free your device from their grasp!
Step 6
– Carefully detach the four wires on either side; these little guys are responsible for those comforting vibrations and the right and left triggers!
Step 7
– Now that you’ve mastered the art of reassembly, just retrace your steps in reverse. It’s as easy as pie!
– Oops! If you didn’t finish this guide, no worries—just take a breather.
– And remember, if you hit a snag, don’t hesitate to schedule a repair for some expert assistance.
Success!
