Xbox One Elite Controller Repair: How to Replace Parts – Step-by-Step Guide
Duration: 45 minutes
Steps: 10 Steps
Step 1
No need to worry about the rubber, it’s already seen better days.
– Use a pry tool to gently pop off the side panels. You’ve got this!
Step 2
– Let’s get started by removing the 5 Torx Security Bit (TR9) screws – this is the first step to unlocking your device’s inner workings!
Step 3
Handle that ribbon with care in the next step; we’ve got your back, so let’s keep it safe and sound!
– Gently pry open the panel beside the 3.5mm port. You’ve got this!
Step 4
Hey, be super careful not to rip that ribbon cable. Take it slow and steady!
– Gently lift the connector to free the ribbon with ease.
– Ribbon Cable
Step 5
– Let’s get started by removing the 2 Torx (T6) screws – this is the first step to unlocking your device’s inner workings!
Step 6
– Time to get desoldering! Carefully remove the 4 wires from each side – these little guys control the vibrations and the RT LT. Take your time and make sure you’re gentle, we don’t want any accidental damage.
Step 7
– Gently lift from the ‘top’ side of the controller on the sister board. You’ve got this!
Step 8
Watch out for that sync button – it’s a sneaky little guy! Keep it safe and sound.
Removing this part will also take out the left and right brackets, which are actually a single unit – don’t worry, it’s all part of the process!
– Gently lift the middle section starting from the home button side. Keep it steady and light-hearted as you go!
Step 9
– Loosen up those 6 Torx (T6) screws and set them free!
Step 10
– To put everything back together, just follow these steps in reverse – easy peasy!
– If you didn’t quite get it done, no worries! You can always schedule a repair and let the pros handle it.
– You’re almost done! Take a deep breath, and you’ll be enjoying your freshly repaired device in no time.
Success!
